Saddle Stool tall enough for Longarm Frames

Many longarmers get tired of standing all the time and want a chair/stool to sit on, particularly when doing tight, delicate micro-quilting. Most common stools, drafting chairs, and mechanics stools aren’t tall enough to elevate a quilter to the standing position while sitting.

After a lot of research, test-driving a number of stools at retailers and quilt shows, we got the stool shown from a industrial furniture company. Even though we ordered the tallest version they offered, it was still too short so a little more investigation found a taller pneumatic cylinder which made the stool the height needed - it was easy to install - the cylinder pops in and out of the chair and base with very little effort.

Here is a picture of the stool in use - my wife has enjoyed for more than a year.

 
Saddle Stool in use.jpg
 

After switching to the taller cylinder, at it’s lowest position the saddle stool is 28” high, and at it’s tallest is 36” - the original levels were 21” and 27” respectively - so not only is there more height there is an additional 2” of range of elevation.

Stool Height Comparison.jpg

If you are interested in this stool/cylinder combination the stool can be found here - manufactured by Champion Seating with customers such as Shell, Ford, and the State of Texas - at time of publication the cost was $215.00.

The pneumatic cylinder can be found here supplied by ChairPartsOnline.com. At time of publishing the cost was $34.00 with free shipping.

If you have questions on the stool/cylinder combination or any other longarm technology questions, please submit them in the Contact Us section below, and, as always…

Quilt on!


Do you have questions on this topic or a suggestion for another one you are interested in?

Embed Block
Add an embed URL or code. Learn more
Embed Block
Add an embed URL or code. Learn more